CosmOS had 1,161 bytes of Program Memory left before the address applications
load at, and Tab completion is not going to fit in that with anything to spare.
So the wall moves up one page: the system keeps below 0x4FFF and 0x2FFF, and an
application is based at 0x5000 and 0x3000.
A PAGE IS A CHEAP THING TO GIVE IT AND AN EXPENSIVE THING TO RUN OUT OF. An
application still has 44K of Program Memory before the vector table and the
largest one here uses 7.5K, so what was taken from applications is space nothing
has ever asked for - while what the system gained is the difference between
building the next thing and counting bytes while building it.
Not doubling, which was the version that would have cost application space worth
minding. One page, and the same again when it is needed.
Nothing in the machine knows where the wall is, so this is 34 #Base lines, one
threshold in the fault handler, and the table in the CosmOS README that
Tests/docs.sh reads its limits out of.
The native assembler's scratch map had to move with it, and docs.sh said so
before anything ran: its data reached 0x40D6 and its buffers began at 0x4000, so
they were sitting on its variables. That file already carries a paragraph about
the floor coming up and the map staying where it was. It has happened twice now,
and been caught by a check the first time wrote.
Twenty three recordings are the same runs a page higher.
Co-Authored-By: Claude Opus 5 <noreply@anthropic.com>
Claude-Session: https://claude.ai/code/session_01E2JrLzFvuFX9fgi1LDRjrW
Until now the only way to restart was to stop the emulator and run it
again, which meant the one thing the machine could not do was the thing
Once was written for. The loop now closes without leaving it:
> Once /System/Boot/bare.bin
next start: /System/Boot/bare.bin, once
> Reboot
starting again
stage two
just this once: /System/Boot/bare.bin
bare metal: no system, just this
Writing 1 to port 0x13 asks the machine to start over. A PORT RATHER THAN A
SERVICE, because a reset has to work when the system does not: something
only askable through SWI would be unavailable in exactly the case that
wants it most, and a program that owns the whole machine has no system to
ask. It is device class 0x04, in the range kept for the machine rather than
among the peripherals, because it is not one - it is not attached to
anything and cannot be unplugged.
WHAT A RESET REPEATS IS HOW THE MACHINE STARTED. Named an image, the
emulator places it again; named none, the ROM is shadowed again and reads
the disk. Anything else would mean a reset changed what the machine IS,
which is the one thing a reset must not do. Both are tested.
Taken between instructions, because a device cannot restart the machine
from inside the instruction that asked: the CPU is part way through a step
and its state is not yet anything a reset could leave behind consistently.
The disk stays attached and keeps everything written to it - that is what
warm means. The vector table is cleared, which is the one deliberate
departure from leaving memory alone: a vector points into whatever
installed it, and after a reset that program is not running, so a handler
left behind would aim an interrupt at an address belonging to something
gone. It is the argument CosmOS already makes at exit, applied to the
machine.
Reboot is 45 bytes, most of them the word it prints.
AnachronautandClaude Opus 5